|
Introduction
The LANtest Pro is a small
hand-held tester that enables the user to quickly read the status
of Ethernet twisted pair cables. It tests for faults such as open
circuits, shorts, crossed pairs, reversed pairs and split pairs
in seconds. The Tone generator function can send a signal through
your installed cables and the probe can then trace the cable to
locate the fault.
The LANtest Pro includes one master unit and one remote unit easily
operated by one person testing patch cords or installed cables.
The small remote unit is designed to slip into the master unit to
prevent loss or damage top
Features
- Tests for wiring faults of open, short, reversed,
crossed and split pairs
- Split pair fault detection at a minimum 40cm
cable length
- Verification of shield integrity
- Specially designed remote unit that enables
one person to test installedcables
- Easy to read fault display and high speed
testing
- Debug mode for detailed fault identification
results
- Auto sleep mode and power off switch to decrease
power consumption
- Low battery indicatortop
Specifications:
- Connectors
LANtest Pro Main Unit - RJ45 jack
Remote Unit - RJ45 jack
- Pairs testes
1/2, 3/6, 4/5, 7/8 and shield
- LED display
Horizontal: 5 Green LEDs for pairs and shield
display
(1-2, 3-6, 4-5, 7-8 and SHIELD)
Vertical: 5 Red LEDs for fault display
(OPEN, SHORT, REVERSED, CROSSED, SPLIT PAIRS
and LOW BATTERY)
- Cables test length limit
Minimum: 0.4m Maximum: Over 200m
- Power
6V alkaline DC battery (not included)
- Remote identifier
no battery required
- Dimensions:
LANtest Pro - 125 x 52 x 30 mm (L x W x H)
top
|
